Steel Caster Store

This Texas Star style sliding interior double barn door kit is perfect for anyone looking to install a DIY barn door. It can be painted to meet your design style or used as is for a rustic look. The barn door kit includes everything you need besides the tools to install it. Basic installation instructions will be included and other helpful hints can be found online.

General Information

 - The track is not predrilled to allow you to 5/16" drill holes at the necessary locations

 - Hardware works with doors of 1-1/4" to 2-1/4" Thickness (For doors wider than 1-7/8", please contact us so we can send a wider door guide)

 - All lengths of track 7-12 feet and over will come in two pieces with splice kit included. Track lengths from 13-16 will come in three or four pieces with splice kits included 

 - Track hangs 1-11/16 off wall – A backer board might be needed depending on your application

 - Track Lengths are 4" longer than the stated length (i.e. if you select an 8 foot track, it will come 8 foot 4 inches to accommodate end stops)

 - 200 Pound Door Capacity (Using both Hangers)

 - General Rule: Track length needs to be double the size of the door

The parts included are as follows:

• Four Texas Star style hangers with 3" cast iron wheel - Hanger Length is 14" total and 10" from wheel base to end of hanger and 1.5" wide x 3/16" thick. The holes to attach to the door are located .5" and 6.5" from the bottom of the hanger. The rosette is 5-3/8" in diameter.  

• 15 Foot Long x 1-1/2" Wide x 3/16" Thick Track (Total Track length is 15'4" - end stops take up 2" per side)

• All hardware to attach track to the wall -
• 1-5/8" Spacers that goes between the track and wall - Track will hang 1-11/16" from wall with the spacer and washer that goes in between. Longer spacers and bolts or a backer board can be used if additional length from wall is needed. (Not Included)
• Washers to be placed behind spacers 
• 5/16" x 4.5" Lag Bolts to attach track to wall
• 5/16" x 1-1/2" Lag Bolts to attach hangers to door
• 2" x 2" angle iron end stops 
• 2 safety anti-jump clips to prevent possible derailment with 1/4" x 1-1/2" lag bolts
• Floor mounted door guide fits doors up to 1-7/8" width or can be used with a 1/8" mortise or kerf cut on the bottom of the door (for wider door guides, please contact us)
• Made from Quality Steel in the USA

Call with Questions 1-800-345-0425 or 713-227-1144 (Mon.-Fri. 7am-430pm CST) 

Email: sales@steelcasterstore.com